Photon Booster LED module, Red or Yellow
The Photon Booster is the LED module used in our Photon Blaster and P3 Lights visibility lighting systems. The module is available in ye [Read more ...]
Product code: 101721
Manufacturers code: SKE-P3-Booster-Lights
The Photon Booster is the LED module used in our Photon Blaster and P3 Lights visibility lighting systems. The module is available in yellow for front or side mount applications, and red for rear mount applications.
The module consists of 12 high-brightness LEDs mounted in a waterproof housing. A 4mm stainless steel mounting bolt protrudes 7.5mm (0.3") from the rear of the housing, and is designed to work with a variety brackets available from us or your own mounting bracket.
An installation guide, a 4mm stainless steel locking nut, and two Posi-twist® connectors are included. Sold in pairs.
Skene Design has a 2 year warranty in the event of any defect in the product.
Current draw: 0.14A
Operating voltage: 9 - 16 VDC
LED intensity: total of 252,000 mcd
Intensity regulation: the LED module incorporates a current regulator to maintain maximum LED brightness even under low voltage conditions.
Angle of half intensity: 15 deg;
Wavelength: 592 nm (yellow), 612 nm (red)
Dimensions: 3" x 0.625" x 0.35"
Weight: 3/8 oz.
These lights are designed to be an addition to the P3 lights or the Photon Blaster lights, remember you cannot have a yellow light showing at the rear, the yellow lights can only show at the front and side of a vehicle, Red lights can only show at the back of a vehicle, in the UK they should also not flash unless they are repeater indicator lights.
These lights can be wired direct without a controller but they will be very bright, thats probably fine if using the yellow light as a front running light but the red light will be too bright as a rear light as it will be as bright as a brake light.