Made of 1 inch stainless steel, th [Read more ...]
£348.21
Product code: MU10-0-1002
Manufacturers code: MU10-0-1002
Made of 1 inch stainless steel, these crash bars are built with precision-manufactured mounts that integrate directly into the motorcycle’s frame through the motor mount. They are self-reinforced by a cross bar, and wrap protectively around the fairings, radiator and water pump. The AltRider Crash Bars are made with a shot peen satin finish, so even after the bike takes a spill the stainless bars will never show signs of rust.
Seamless installation of frame sliders rounds out an attractive and strong solution. Made from abrasion and impact resistant plastic, these sliders integrate seamlessly into the AltRider Crash Bar mount by attaching via billet aluminum offset, designed to effectively transfer the impact load to the crash bars. Because of the direct mount to the bars, the frame avoids damage that can occur in a crash when frame sliders are bolted directly to the frame itself.
The sliders utilize plastic with good lubrication and wear properties, so AltRider frame sliders can survive a longer slide than those made with other common materials. Additionally, the ability to resist impact is high, making the slider less likely to snap off or crack in a crash. We also chose to use high strength chromoly steel rod instead of commonly used all-thread or stainless steel.
Crash bars are also available in Black.
NOTE: This kit does not include the short engine bolt required to run the crash bars without the frame sliders. If you would like the option to run the crash bars alone, you should order the crash bars and frame sliders individually.
Click the link for instructions
Crash Bar Installation Guide
Frame Sliders Installation Guide