Twin pack Bike wash and After Shine
Product comes with trigger.
Pro-GreenMX/Motoverde Bike Wash is 100% salt-free, with no corrosive components (including acids/alkalines) in the product making [Read more ...]
Pro-GreenMX/Motoverde Bike Wash is 100% salt-free, with no corrosive components (including acids/alkalines) in the product making it the safest cleaner on the market!
Fully biodegradable with recyclable packaging.
Completely safe to use on all surfaces including paints, plastics, anodised parts, sensitive metals (including aluminium) and carbon fibre.
Safe for use on all E-Bikes.
Tough on dirt but gentle to your bike and its parts. Our Bike Wash will remove mud, dirt and grime with ease, whilst also removing sand and clay stains! Can also be used on your kit, boots and helmets.
High-foaming product that clings to your bike and does the work for you!
Contains UV protection to protect your paint colours from fading in sunlight.
INSTRUCTIONS FOR USE Bike Wash
Rinse excess dirt off bike.
Product is ready to use. Simply attach trigger and spray away!
Apply Pro-GreenMX/Motoverde Bike Wash, leaving to soak for 15-20 minutes (5 minutes if in a rush). The longer soak time, the better the results as it is non-aggressive!
Agitate with a brush or sponge if required for stubborn dirt.
For kits: add at least 500ml of product into a bucket of warm water and submerge your kit inside.
You can also throw in your goggles and straps before leaving to soak overnight.
The following morning, remove your goggles and straps and rinse under a tap until all chemical excess has been removed then leave to air dry.
With trousers, place these on the floor and agitate the bottom area with a sweeping brush to loosen excess dirt before placing directly into your washing machine, alongside kit top.
Wash your kit at 30 degrees on a normal wash or sports wash.
At the end of the wash cycle your kit will be the cleanest you have seen it since the day you purchased it!
For boots and helmets: simply spray product all over and leave to soak for 15 minutes before agitating with a brush/sponge if required. Rinse off!
INSTRUCTIONS FOR USE After Shine
After cleaning your bike with Pro-GreenMX/Motoverde Bike Wash, ensure that all traces of WD40 or similar are removed before applying After-Shine.
Whilst the bike is still wet, spray After-Shine directly to the bike surface (DO NOT SPRAY ON SEAT, BRAKES or HANDLEBAR GRIPS).
Once the bike has been covered, walk away and leave to air dry for 30 minutes (DO NOT USE A CLOTH TO WIPE OVER).
Once dried, your bike will possess a high-gloss, protective finish!
For matt-finishes, dilute product 1/3 After-Shine to 2/3 water for protection without the high-gloss finish.
